Cleaning The Motor Block; Storage; Disposal - Silvercrest SSTMC 600 A1 Operating Instructions Manual

Cleaning the motor block

1) Clean the surfaces with a damp cloth. If necessary, apply a mild washing-up
liquid to the cloth. Afterwards, wipe off with a cloth moistened only with
water to ensure that no detergent remains on the appliance. Then dry the
surfaces thoroughly.
2) When cleaning, always check that the contact switch in the fitting for the
blender 3 is not blocked by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.

Storage

1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning").
2) Wrap the power cable around the cable retainer 7 on the base of the
motor block 6.
3) Store the blender in a cool and dry location.

Disposal

Do not dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please comply with all applicable regulations.
Please contact your waste disposal facility if you are in any doubt.
Your local community or municipal authorities can provide information on how to
dispose of the worn-out product.
Note the labelling on the packaging and separate the packaging material
components for disposal if necessary. The packaging material is labelled with
abbreviations (a) and numbers (b) with the following meanings:
1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites.
The packaging is made from environmentally friendly material and can be
disposed of at your local recycling plant.
SSTMC 600 A1
GB │ IE │ NI │ CY │
15 ■