Cleaning The Motor Block; After Cleaning; Storage - Silvercrest 296694 Operating Instructions Manual

NOTE
4) Dry all parts thoroughly before reassembling them .
5) Re-attach the lower plastic part C of the blender 3 to the upper plastic part
A of the blender 3 and turn it clockwise .

Cleaning the motor block

1) Use a dry or no more than slightly moistened cloth to clean the plastic
surfaces .
2) When cleaning, always check that the contact switch in the fitting for the
blender 3 is not blocked by soiling residues . If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services . Do not use any hard objects, these could damage the contact
switch .
3) Remove any possible residues on the underside of the motor block 6 with a
dry cloth or a stiff-bristled brush only . Ensure that nothing can get in through
the ventilation openings of the appliance .

After cleaning

Allow all parts to dry well before reassembling and reusing the liquidiser .

Storage

1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning") .
2) Wrap the power cable around the cable retainer 7 on the base of the
motor block 6 .
3) Store the blender in a cool and dry location .
SSM 600 B2
You can also clean the upper plastic part A of the blender 3 and
the cutting blade 4 with the lower plastic part C in your dishwasher .
GB │ MT │ 69 ■