Advertisement
Available languages
Available languages
Add Engine Oil
1.
Place pressure washer on a fiat, ]eve]surface.
2.
Cleanarea around oil fill and remove oil fill cap/dipstick.
NOTE:See Off Recommendations in Maintenancesection.
Verify provided oil bottle is the correct viscosity for current
ambient temperature.
3.
Using oil funnel (optional), slowly pour contents of both
provided oil bottles into oil fill opening to the point of
overflowing.
NOTICE
Improper treatment of pressure washer can damage it and
shorten its life.
DONOT attemptto crankor startthe enginebeforeit hasbeen
properlyserviced with the recommended o il. This may resultin
an enginefailure.
4.
Replace oil fill cap/dipstick and fully tighten.
Add Fuel
WARHIHG
_Fue]
and its
flammable and
vapors
are extremeJy
explosive.
Fire or explosion can cause severe burns or
death.
WHENADDINGFUEL
* Turnpressure washerOFF and let it coolat least2 rninutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure
in tank.
. Fillfueltank outdoors.
* DONOToverfilltank.Allowspacefor fuelexpansion.
* If fuel spills,wait until it evaporates beforestartingengine.
Keepfuelawayfrom sparks,openflames,pilot lights,heat,and
otherignitionsources.
DONOTlight a cigaretteor smoke.
1.
Use clean, fresh, regular UNLEADEDfuel with a
minimum of 86 octane with equipment. DO NOT mix oil
with fuel.
2.
Place pressure washer on a level surface. Cleanarea
around fuel fill cap, remove cap.
3.
Slowly add regular unleadedfuel to fuel tank. Be careful
not to overfill. Allow about 1" of tank space for fuel
expansion, as shown here.
MaximumFuelLevel
4.
Install fuel cap and wait for any spilled fuel to evaporate.
CAUTION! Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be treated
with a fuel preserver or emptied before storage of 30 days or
longer. If adding a fuel preserver, fill the fuel tank with fresh
fuel. if only partially filled, air in the tank will promote fuel
deterioration during storage. If fuel preserver is not used,
drain the fuel tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel next season.
See Storage for additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
Advertisement
