Figure 5: Microsim And Microsd Cards - Motorola L6Q Installation Manual

● Verizon Mobile
● AT&T Mobile
● FirstNet Mobile
CAUTION: A consumer grade SIM card that is not configured for use with L6Q cameras will incur
excessive voice billing charges from the carrier! Voice charges are considered legitimate and cannot be
disputed. Only approved Internet of Things (IoT) SIM cards configured for L6Q data should be used
with the L6Q camera. Contact Vigilant Support for questions regarding cellular carriers and approved
SIM cards.
2.5.1
Installing a SIM or SD Card
The MicroSIM and MicroSD card slots are located in the battery compartment of the camera.
Prerequisites: Obtain one or both:
● MicroSD Card
● MicroSIM Card
Procedure:
1. If the Battery Tray is inserted, remove it from the camera.
The camera is shipped without the battery tray inserted.
2. Identify the card slot types and proper card orientations.
Refer to the labels by each slot in the battery compartment.

Figure 5: MicroSIM and MicroSD Cards

3. Orient the card as indicated by the label and slide the card into the correct slot.
4. Press gently on the card until it clicks into place.
CAUTION: Do not forcefully insert the card into the slot. Doing so may damage the card or the
slot. If the card does not slide in easily, re-check the card orientation and slot type.
5. To remove a card, press gently until it clicks out of place.
2.6
Installing the Camera Batteries
The camera is powered by two internal Camera Batteries that are inserted into the Battery Tray. If needed,
the individual batteries or the whole Battery Tray can be swapped out before or after installation. Install the
Camera Batteries before attempting to power the camera from one of the available power options.
MN010089A01-AD
Chapter 2: Pre-Installation
35