Motorola L6Q Installation Manual page 51

Procedure:
1. Choose one of the following options:
If...
If the Solar
Panel is being
mounted to a
pole,
If the Solar
Panel is being
mounted to a
flat surface,
2. Lift the Solar Panel by the Shoulder Strap and bring it to the mounting location.
CAUTION: The assembled Solar Panel is heavy. Do not attempt to ascend a ladder with
additional items while mounting the Solar Panel.
3. Hook the Solar Panel over the top of the mounting bracket hook and into the top of the mounting
bracket.
CAUTION: Ensure that both the Solar Panel hook and the Mounting Bracket hook are engaged.
4. Obtain the Hex Bolts (2x) and Hex Key Tool.
5. Thread the Hex Bolts (2x) through the mounting holes at the top of the Solar Panel and into the
mounting bracket.
6. Securely tighten the Hex Bolts (2x) with the Hex Key Tool.
Then...
install the Solar Panel Mounting Bracket with two Metal Band Straps:
a. Position the bracket facing a southerly direction.
b. Temporarily secure the top loops of the bracket with a Zip-Tie.
c. Loop the Metal Band Straps through the mounting loops to secure the
bracket against the pole.
d. Fasten the straps with the Hex Key Tool.
e. Remove the temporary Zip-Tie.
f. Trim the excess material from the Metal Band Straps.
install the Solar Panel Mounting Bracket with two Lag Bolts:
a. Ensure that the mounting surface is flat, and that the surface material is
capable of supporting the full weight of the assembled Solar Panel.
b. Insert a drill bit into the Power Drill chuck.
c. Hold the bracket against the surface with the hook facing away from the
surface.
d. Adjust the bracket to its final mounting location and tap two mounting holes
through the lag bolt holes.
e. Equip the Power Drill chuck with a socket bit and Lag Bolt.
f. Screw the Lag Bolts through the bracket and into the surface.
g. Tighten the Lag Bolts securely.
MN010089A01-AD
Chapter 3: Hardware Installation
51