Table of Contents
Advertisement
English
2 Place the handheld close to the radio aligning the
Bluetooth Pairing Location on the handheld with the
Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an
incremental-pitched tone from the radio. The radio
begins to connect to the handheld. If the connecting
process is successful, you hear an incremental-
pitched tone. The display shows <Device Friendly
Name> connected, and the Bluetooth icon turns
from
to
.
If unsuccessful, one of the following scenarios occur:
•
You hear a short, low-pitched tone and the
display shows Bluetooth pairing failed (if
pairing fails).
•
You hear a decremental-pitched tone and the
display shows <Device Friendly Name>
unpaired (if the connection fails within 6
seconds).
•
You hear a short, low-pitched tone and the
display shows <Device Friendly Name>
connect failed (if the radio has the pairing
record of the handheld and the connection fails).
Repeat this step to re-initiate the pairing process.
176
NOTICE:
To unpair the handheld after a successful
connection, follow the steps in
Clearing the Bluetooth Device Information on
page
173.
Holster Sensor
Holster sensor allows the radio to send notification over-
the-air (OTA) when a holster event or multiple holster
events occurs.
To enable the feature, ensure that the GPS, Enhanced
Data, and Bluetooth feature of your radio is on and the
radio supports Bluetooth Low Energy (BT-LE).
You can disable the sensor temporarily or permanently.
This feature allows you to suppress one or all holster
events from being reported OTA.
The radio triggers a visual and audible notification when the
holster sensor battery is below the preset threshold value.
The radio displays <BT alias> low batt and a tone
sounds.
This feature is enabled through CPS configuration. Check
with your dealer or system administrator for more
information on the programming of this feature.
Viewing and
Advertisement
Table of Contents
