Handling; Setting The Ait Data Cartridge - NEC Built-In AIT User Manual

Handling

The following explains how to handle the Built-In AIT.

Setting the AIT data cartridge

Important
• As the data cartridge to be set in the magazine, use our "AIT Data Cartridge". If you use a data
cartridge of other manufacturer, a read/write error may occur.
• While setting the data cartridge, do not turn off the basic processing unit. This may cause a
malfunction or damage to data.
1
Turn on the basic processing unit. Check
that the drive's REPLACE TAPE LED,
TAPE MOTION LED and CLEANING
REQUEST LED go off.
2
Open the dust cover.
3
Set the AIT data cartridge orienta-
tion as shown here and insert it into
the data cartridge slot.
By inserting the data cartridge to the
extent, it is automatically set in the
drive and the TAPE MOTION LED
lights.
Important
When a new (blank) data cartridge is set, it will take a few minutes before the TAPE MOTION LED
lights up.
40 Built-in AIT