Husqvarna PP492HF Workshop Manual page 154

12
3
4
1 5 4
FIRMWARE UPGRADE
3� 1� Connect Multiprogrammer to
a PC running Common Service
Tool (CST)�
2. Wait until CST identifies the
connected Power Pack, PP400
series�
3. Click Update firmware.
4� Select PowerPack model, the
interface FKD 10 and firmware
in the dropdown menus� Click
Update�
5� Wait for the update to be
completed� NOTE! Do not
disconnect the Multiprogrammer
before the firmware update is
complete�
4� Disconnect the Multiprogrammer
from the PowerPack and connect
the controller boards power sup-
ply cable�
To complete the firmware update
for PP440 continue in Firmware
update for PP 490, PP 492 in
section: Main Board side (p� 149)