Inspect The Clutch - Husqvarna PP492HF Workshop Manual

10.2
1
3
5
78
REPAIR INSTRUCTIONS
WS482 and
2
WS442
4
WS482 and 6
WS442

Inspect the Clutch

WS482 and
WS442
Note: Preferably use a dial torque
wrench. A click type torque wrench
will measure the top valve for the
slip and not the torque in motion.
First see:
77)
WS482 and
1� Remove the blade motor shaft by
WS442
pulling it out by hand�
2� Tap the shaft against a table to
remove the three pins�
3� Place the pivoting arm in the
Special Tool nr: 522 90 84-01�
4� Grease the three pins and insert
them in the grooves� Then place
WS440
a 16mm socket over the shaft and
pins�
5� Use a torque wrench to see at
what torque the arm is slipping�
For a WS482 in 2:nd gear, the
toque value should be 70-85Nm,
recorded while the clutch is
slipping�
For a WS482 in 1:st gear the value
is about 10 Nm lower�
Test in both directions�
6� To check the slip clutch for a
WS440 attach the special tool 523
05 78-01 to the torque wrench�
A WS440 should slip at 70-85Nm�
Test in both directions�
Detach Arm/Housing (p.