Advertisement
Available languages
Available languages
B-500/A/BIG
(9) Push the brake solenoid under the right side of the
sheet board to release the brake.
Pull out the white sheet by hand slowly. (Figure 25)
\
\
Figure 26
(10)
Push the sheet bobbin holder lever in the upper part
of the right side Board, and remove the upper part
of the white sheet bobbin. (Figure 26)
/'I f:
(11) Lift up the white sheet bobbin and draw it out from
the lower white sheet holder.
(12) While rolling up the white sheet TIGHTLY on the
bobbin which was drawn out, carry the bobbin from
the right side of the board to the left side. (Figure
27)
Figure 27
(13) On the left side, follow the same
procedures
as
described in (10) and (11) to draw out the bobbin.
(14) After taking out the bobbin, retain it with a rubber
band. (Figure 28)
Figure 28
2) Reassembly
(1) Wind up the white sheet TIGHTLY on the right side
roll.
(2) For replacement of the white sheet, take out the roll
hub unit from the removed white sheet, and insert it
to the new white sheet bobbin.
Figure 29
Advertisement
