Advertisement
Available languages
Available languages
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
While Holding the white sheet, insert the bobbin
into the
bobbin
holder
in the bottom
left of the
board, match the notch of the bobbin, to the Notch
DF
Press the upper part of the white sheet bobbin into
the
notch
of the
upper
white
sheet
holder
to
complete the installation of the left side white sheet
bobbin.
While paying attention not to loosen the Rolled up
end of the white
sheet, feed
out the white sheet
slowly and carry it to the right side of the board.
Note:
When moving to the right side, press the upper and
the lower
ends
of the bobbin
lightly with your
fingers to contact them to the board face for parallel
movement.
Insert
the
white
sheet
bobbin
into
the
bobbin
holder, matching the lower side notch of the sheet
bobbin to the bobbin holder.
Press the upper part of the white sheet bobbin into
the
notch
of the
upper
white
sheet
holder
to
complete
the installation
of the right side white
sheet bobbin.
Piug
in the
power
supply
cord
and
turn
on
the
power switch for an E6 indication.
Push the Frame Shift button[<] to wind up the
white sheet towards the Left for about 5 seconds.
Then turn off the power switch.
Insert
the
white
sheet
between
the white
sheet
holder and the board at both upper and lower ends.
Turn on the power switch again and check that the
initial setting is correctly made.
Note: (The unit is in normal condition if the indica-
tor displays FRAME 1 and COPIES 0.)
Hold the top and the bottom of the board at the
board
center,
and while
lifting the board a little,
hook
it on
the
main
frame
with
the
upper
part
fixture.
Press
upon
the stay at the bottom
inside of the
board lightly with your hand and Reform
it. Press
the bottom of the board against the main frame.
Figure 30
17
VB-500/A/Bi
Lever
=
¢
3
Figure 31
| PUSH
Figure 32
Advertisement
