Advertisement
Installation
Model 11869A
Figure 2~5.
Installation (4 of 6)
f
6.
Option 004; Connecting the RF OUT Cable
If the RF Plug-In is a model 86290A/B/C, clip off and discard the
chain attached to the AUX OUT cover and the heat sink, to avoid
possible short circuits on the Connector Board.
Select the correct semi-rigid Option 004 cable for the Plug-In
used. Cable number 11869-20003 is used with the 86290A/B/C*and
cable number 11869-20002 is used with all others. Set the Plug-In
right side up on a flat surface. Connect the Type-N(m)
connector
of the semi-rigid cable to the rear-panel RF OUT connector of the
Plug-In. Keep the semi-rigid cable approximately parallel to the
work surface and tighten the N-connector nut by hand.
The SMA end of the semi-rigid Option 004 cable is connected to
the inside of the rear panel RF OUT connector on the 11869A
Adapter at the same time as the Adapter is mated to the Plug-In.
(See Mating the Adapter to the Plug-In below).
CAUTION
Do not over-tighten the SMA nut on the
semi-rigid RF OUT cable„ Excessive torque
may cause internal damage to the cable
connection. Tighten the nut snugly only.
After the Option 004 cable is connected to the 11869A Adapter and
the Adapter is mated to the Plug-In, carefully tighten the SMA
nut on the output end of the RF OUT cable, using a 5/16-inch
wrench. Do not overtorque, as internal damage to the cable
connection may result.
7.
Option 006; Connecting the AUX OUT Cable
Remove the cover from the AUX OUT on the rear cover of the
Plug-In, and clip off and discard the chain to avoid possible
short circuits on the Connector Board.
To connect the AUX OUT cable,
follow the instructions given above
for the Option 004 rear-panel RF OUT cable, except connect the
cable to the AUX OUT connector of the Plug-In and to the inside
of the AUX OUT connector on the Adapter. If the Plug-In is an
86290A/B/C Option 004, connect both the RF OUT and the AUX OUT
cables to the Plug-In before mating the 11869A Adapter to the
Plug-In.
2-8
Advertisement
