Index Sensor Assembly - Sharp FDD-412A Service Manual

FDD412A/B
4.2.9 Protect Sensor Assembly
(1) Tools and measured instruments to be used:
#2 Phillips screwdriver
Small flat screwdriver (for wire removal)
(2) Disassembling
(a) Remove the PWB according to 4.2.4.
(b) Remove the protect sensor wiring off the J3 connector
according to 4.2.3.
(c) Detach the bail assembly according to 4.2.7.
Cd) Remove a protect sensor set screw (M4 x1).
(3) Assembling
(a) Align the positioning dowel with the plate hole, and tighten
the set screw.
(b) Attach the bail assembly according to 4.2.7.
(c) Install wiring according to 4.2.3 (wire routing shown in
Fig. 4.5.)
(d) Install the PWB according to 4.2.4.
a |
Bail assembly
Fig. 4.11 Protect Sensor Assembly
4.2.10 Index Sensor Assembly
(1) Tools and measuring instruments to be used:
#2 Phillips screwdriver
Small flat screwdriver (for wire removal)
(2) Disassembling
(a) Remove the top cover according to 4.2.1.
(b) Open the plate according to 4.2.2.
(3) Assembling