Advertisement
Set the mode no. to "3".
Communication test is performed between the wireless remote controller and the wireless re-
ceiver.
When the display shows " ", this indicates that the communication between the remote controller
and the receiver is established. If "
cating with the wireless receiver.
Do not leave the wireless remote controller in a location where the communication test results
in "
".
EN
Set the mode no. to "4".
Select either displaying or hiding the room temperature.
Touch
or
to save the setting.
"
Actual room temperature is displayed
When the indoor unit is operating, the room temperature display shows the actual room temperature
able temperature range is from 0°C to 40°C.
Set the mode no. to "5".
When the automatic zone no. display is active, a zone number assigned to the remote control-
ler is displayed for 3 seconds after temperature setting.
Touch
or
"
The zone no. ( or
11
button to select displaying or hiding the room temperature, and touch
".
button to select between "
".
" is shown, the wireless remote controller is not communi-
<Remote controller Display>
" and
or
) assigned to the remote controller is shown.
, and touch
button to save setting.
button
-
Advertisement
