Advertisement
Run the receiver's cable into the cylinder unit
through the inlet as shown on the figure.
Route the cable out the back of the control and electrical box, and run the cable into the box
through the shown inlet in the underside of the box.
Control board
EN
Connect the cable connector to the CNRF terminal on the control board. Switch ON SW1-8.
Remove excessive slack on the cable , then secure the cable with a cable fastener and 2 ca-
ble straps on the upper side and center on the back of control and electrical box.
5
Control and
electrical box
Cable
fastener
Cable
straps
Receiver's cable
SW1
Control and
electrical box
CNRF
Control and
electrical box
Advertisement
