Table of Contents
Advertisement
Diagnosis
Poor drain
(5) Whether the drain hose is connected to the drain pipe
No drain
tightly. (Whether it is warning alarm condition.)
Hard to drain
(6) Whether the drain hose collapses.
(Whether it is warning alarm condition.)
(7) Whether the drain hose is blocked.
(Whether it is warning alarm condition.)
Note:
Keep the gap between the top of the rubber pipe and the
washer pan.
6
At washing and rinsing process, reverse rotation is performed
At end of rinse or
to loosen fixed clothes for the last 20 sec.
washing operation,
reverse rotation
period is short.
7
(1) Whether automatic correction mode for uneven loading is
Washing operating
performed during operation.
time is longer than
(As the procedure (water supplying-stirring <1 min.> -
usual.
drainning) is automatically performed, if the fixed clothes
are loaded unevenly, the total operation time is prolonged.)
(2) Whether the drain hose is placed too high due to threshold,
etc.
[If the drain hose is placed too high, large volume of
bubbles are generated during the RINSE or SPIN process
and the spin speed does not increase properly. In such
case, [fill water → stirring time (1 min.) → drain] processes
are automatically activated, and the operation time will be
prolonged for these processes.]
All manuals and user guides at all-guides.com
Check Point
Rubber pipe
– 19 –
Make a gap.
Replace the drain hose if it
collapses.
Make a gap.
Cut the drain hose
obliquely.
A gap should
be more than 3 cm.
This is not trouble.
This is not trouble.
Make sure whether it is
placed on a firm and flat
floor.
Same as 5 - (2).
Remedy
A gap
A gap should
be more than 3 cm.
A gap
A gap should
be more than 3 cm.
Cut the drain
hose obliquely.
Advertisement
Table of Contents
