Table of Contents
Advertisement
Parts
1) Remove the top cover according to the (8)
(9) Revolution
Motor disassembly procedures # 1) to 8).
sensor
2) Remove the revolution sensor while rotate
counterclockwise pushing 3 cathes of the
revolution sensor. (Photo. 17)
3) Remove the magnet after removing the
stop ring with a nipper. At the moment, take
care not to damage the shaft of the motor.
(Photo. 18)
(10) Pulsator
1) Loosen the tightening set screw and remove
the pulsator by handling it at the base
section.
(Photo. 19)
Note 1 : When removing the pulsator from the
Note 2 : Be careful not to lose the washer
1) Remove the top cover according to the (3)
(11) Wash tub
(Spin basket)
Lid switch disassembly procedures # 1) to 5).
(Photo. 20)
2) Remove the tub cover (4 catches).
(Photo. 21)
3) Remove the pulsator in the same steps
described in (10) Pulsator.
4) Remove 4 hex. bolts (size 10 mm) at the
bottom of the spin baket, and lift the spin
basket up and out.
(Photo. 22)
All manuals and user guides at all-guides.com
Procedure (
: Notes)
basket, take care not to damage the
basket.
mounted under the pulsator.
– 29 –
Illustrations
(Photo. 17)
(Photo. 18)
(Photo. 19)
(Photo. 20)
(Photo. 21)
Advertisement
Table of Contents
