Toshiba AW-G9930S Service Manual page 27

Parts
(4) Water level 1) Remove the top cover according to the (3)
sensor Lid switch disassembly procedures # 1) to
5). (Always disconnect the lead wire from
the cabinet first.)
2) Disconnect lead wires of the water level
sensor (connector 3P). Remove the water
level sensor by releasing 2 hooks on the
holder, and then remove the air tube.
(Photo. 10)
*
Follow the reverse order of removal.
Note 1 : When replacing the water level sensor,
(5) Lid, Lid 1) Remove the top cover according to the (3) Lid
spring switch disassembly procedures # 2) to 3).
2) With the lid open, first remove the hinge of left
side to the machine. First insert a screwdriver
(–) between the top cover hinge and the lid
arm to open the hinge, and lift up the lid and
remove the hinge gently taking care not to
break it. Then remove the hinge on the right
side and take off the lid. (Photo. 11)
Note 1 : When removing the lid, take care not
Note 2 : Take care not to deform the lid spring
When assembling, following the precedure
*
given below.
Mount the lid spring leg (longer) to the right lid
*
arm, place the shorter leg on the lid hook slot,
insert the right arm first into the top cover
hinge. Open the lid, approach the arm hole
above the top cover hinge and push strongly
the left side of the tub. Then the top cover
hinge is inserted into the lid arm hole. (Fig. 5)
Note 1 : Make sure that the lid opens and closes
All manuals and user guides at all-guides.com
Procedure ( : Notes)
set the groove of the top cover in the
direction of the water level sensor
together as below.
groove of the top cover
to break the hinge section.
mounted at the lid arm (right side).
smoothly after it has been replaced.
– 26 –
Illustrations
(Photo. 10)
(Photo. 11)
Place on the lid
Top cover
hook slot Top cover hinge
Lid spring
Lid arm
(Fig. 5)
Lid