Assembly; Operation - Husqvarna T 4000 Petrol Operator's Manual

Introduction
WARNING:
safety chapter before you assemble the
product.
General
Make sure that the following accessories are included:
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
generator a minimum of 30 seconds before
you start the dust extractor.
To do before you operate the product
WARNING:
injury, make sure that you attach the product
plug fully to the extension cable. Do regular
checks of the connection while you operate
the product to make sure that it is fully
attached. Do not use an extension cable that
makes a loose connection.
Note:
Read the operator's manual of the attached
equipment carefully. If specified requirements or settings
are given for the secondary product, make sure that you
obey these.
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
page 13 .
3. Make sure that the work area is clean and bright.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
5. Make sure that the product is installed correctly.
6. Make sure that the frequency and voltage shown on
the type plate agrees with the power supply voltage.
This is also applicable for the extension cables.
7. Make sure that the power plug is connected
correctly.
10

Assembly

Read and understand the

Operation

Before you operate the
You must start the
To prevent the risk of
Maintenance on
• The hose with end fittings
• Steel tube
• Floor nozzle
If a part is missing, speak to your local Husqvarna
service agent.
Discard the package and the used product components
in correct procedure. Refer to local disposal regulations.
Make sure to recycle.
To fill fuel
Use unleaded gasoline. Do not use gasoline with more
than 10% ethanol and do not use E85 gasoline.
CAUTION:
1. Stop the engine and let the product become cool.
To stop the generator on page 13 .
Refer to
2. Make sure that the product is on level ground and in
an area with good airflow.
3. Remove the fuel tank cap.
4. Carefully fill the fuel tank (A). Fill fuel (B) to the mark
(C).
A
5. Clean the product from fuel spillage.
CAUTION:
risk and can cause damage to the
environment.
To monitor the filter conditions
The product has a manometer to monitor the filter
conditions. The manometer shows the total load of the
product in 3 levels, (A) maximum vacuum level (0 m/s),
(B) filter cleaning level and (C) level without load.
Do not mix gasoline with oil.
B
C
Fuel spillage is a fire
2065 - 001 - 12.06.2023