Husqvarna T 4000 Petrol Operator's Manual page 8

• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
• Do not make modifications to safety devices.
Dust extractor power switch
Use the power switch to start and stop the dust
extractor.
Push the green button (A) to start the dust extractor.
Push the red button (B) to stop the dust extractor.
To do a check of the dust extractor power
switch
To start the dust extractor on page 12 and
1. Refer to
To stop the dust extractor on page 13 .
2. Make sure that the power switch starts and stops the
product.
Generator power switch
The generator power switch starts and stops the
generator.
8
A
B
A
B
I
O
To do a check of the generator power switch
• Disconnect the battery charge cable.
• Set the power switch to the "1" position. Make sure
that the display comes on.
• Set the power switch to the "0" position. Make sure
that the product stops immediately and that the
display goes off.
Generator circuit breaker
The circuit breaker prevents overload in the generator.
Information about rated value of the circuit breaker is
shown near the circuit breaker.
Generator ground terminal
The ground terminal makes sure that the product is
correctly grounded. Before each operation, a ground
wire must be connected to the ground terminal.
Dust extractor grounding braid
WARNING:
grounding braid is in place and in contact
with the ground.
Muffler
WARNING:
without a muffler, or with a faulty muffler. A
damaged muffler may substantially increase
Make sure that the
Never use a product
2065 - 001 - 12.06.2023