Troubleshooting; Open Source Software Notice Information - LG 55UH65 Series Preparation For The First Turn On

Coloured buttons These access special functions in some menus.
( : Red, : Green, : Yellow,
Teletext buttons ( ,
teletext.
You can zoom in on the area where the remote control is
pointed.
By zooming in on the selected area, you can view it in
full screen.
Registering magic remote
How to register the magic remote
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
the remote control.
* If the TV fails to register the Magic Remote, try again after turning
the TV and back on.
How to deregister the magic remote
Press the BACK and (HOME)
seconds, to unpair the Magic Remote with your TV.
* Pressing and holding the
ister Magic Remote at once.
Licenses
licenses, visit www.lg.com.
Open source software notice
information
To obtain the source code under GPL, LGPL, MPL and other open source
licenses, that is contained in this product, please visit http://opensource.
lge.com.
In addition to the source code, all referred license terms, warranty
disclaimers and copyright notices are available for download.
LG Electronics will also provide open source code to you on CD-ROM for a
charge covering the cost of performing such distribution (such as the cost
of media, shipping, and handling) upon email request to opensource@
purchased the product.
: Blue)
) These buttons are used for
Wheel (OK) on
button will let you cancel and re-reg-
(Only UH95**, UH85**, UH77**,
75UH78**, 70UH70**)
External control device
setup
To obtain the external control device setup information, please visit
www.lg.com.

Troubleshooting

Cannot control the TV with the remote control.
• Check the remote control sensor on the product and try again.
• Check if there is any obstacle between the product and the remote
control.
• Check if the batteries are still working and properly installed (
to , to ).
No image display and no sound is produced.
• Check if the product is turned on.
• Check if the power cord is connected to a wall outlet.
• Check if there is a problem in the wall outlet by connecting other
products.
• Check the power control settings. The power supply may be
interrupted.
• Check if the Sleep Timer / Timer Power O is activated in the
TIMERS settings.
Check if the Auto Power O is activated in the General -> ECO
MODE settings. (Depending on model)
• If there is no signal while the TV is on, the TV will turn off
automatically after 15 minutes of inactivity.
When connecting to the PC (HDMI), 'No signal' or 'Invalid Format' is
displayed.
• Turn the TV off/on using the remote control.
• Reconnect the HDMI cable.
• Restart the PC with the TV on.
17