Installing The Coin Cell Battery; System Fan; Removing The System Fan - Dell YRC3G Owner's Manual

Installing the coin cell battery

1 Place the coin-cell battery into its slot on the system board.
2 Press the coin-cell battery with positive (+) side facing up until the release latch springs back into place and secures it to the system
board.
3 To install:
a side cover
4 Follow the procedure in

System fan

Removing the System fan

1 Follow the procedure in
2 Remove the:
a side cover
b air shroud
c front bezel
d ODD
e 5.25 inch ODD bracket
3 To remove the system fan:
a Press the connector tab and disconnect the two fan cables from the system board.
NOTE: Do not pull the connector by the cable wires. Instead, disconnect the cable by pulling on the connector end.
Pulling on the cable wires may loosen them from the connector.
40 Removing and installing components
After working inside your computer.
Before working inside your computer .