Table of Contents
Advertisement
CONNECTING
EXTERNALVIDEO
SOURCES
The exact arrangement you use to connect the VCR, camoorder, laserdise player, and DVD player to your TV set is dependent on the
model and features of each component. Check the owner's manual of each component for the location of video and audio inputs and
outputs.
The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your
particular assortment of components and features.
For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating External Video Source
The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the INPUT button as necessary to view the input source. (See page 28.)
INPUT MODE SELECTION
ORDER
(Antenna)
(Input)
12
Input
--
VIDEO
NOTE:
When the "IV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the back panel of the TV (i.e.,
VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF.
CONNECTING
A MONAURAL
AUDIO
VCR OR LASERDISC
PLAYER
1.
Connect the cabTefrom the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack on the TV set below.
2.
Connect the cable from the AUDIO OUT of the VCR or the laserdisc player to the INPUT (MONO)/L(AUDIO) jack.
3.
Press the INPUT button to view the program from the VCR or the laserdisc player. The VIDEO mode disappears automatically
after approximately eight seconds.
4.
Press the INPUT button to return to the previous channel.
RearPanelofTelevision
0
AUDIOOOUT
0
I Back of
V_DE00UT I VCR
I
Hitachi M odelor
Similar Model
17
Advertisement
Table of Contents
