Advertisement
f.
Press the Set button to scroll through the remaining options for the selected setting until you see the one
you want. Press the Item
g.
Repeat Step f for any other settings you want to change.
h.
When you finish, press the Menu buttons (Item
Your new settings become the printer's defaults.
Turning Off the Lock-Out Mode: You can turn off the lock-out mode easily by using buttons on the control panel.
Follow the steps below to turn off the lock-out mode.
a.
Make sure the printer is turned off.
NOTE: Whenever you turn off the printer, wait at least 5 seconds before turning it back on; otherwise, you may
damage the printer.
b.
Press and hold both the Load/Eject and Pause buttons. While these buttons are pressed, turn the printer
on and the printer will beep once, indicating that the default-setting menu is unlocked.
To turn on the lock-out mode, repeat steps a and b. The printer beeps twice, indicating that the lock-out mode has
been turned on.
MXL System
1. Installation of the PAL-1 in an MXL system requires that a Siemens model ANN-2 or ANN-3 is installed in
the system. The ANN-2 and ANN-3 come installed in an MKB-5 or MKB-6 respectively. An ANN-3 is also
included in model RCC-3.
2. Refer to the MKB-5/-5C Installation Instructions, P/N 315-048727, the MKB-6/-6C Installation Instructions, P/N
315-048722, and the RCC-3/-3R/-3C/-3FC/-3FR Installation Instructions, P/N 315-048665, for more details on
connecting and programming MKB-5, MKB-6 and RCC-3 modules respectively to a PAL-1 printer.
3. Figure 4 shows the proper installation of a PAL-1 with an MXL system.
MKB-5
MKB-6
PARALLEL
PORT
NOTES:
1.
Connect the PAL-1 printer to parallel port on the side of ANN-2 or ANN-3.
2.
PAL-1 printer is supervised for paper out, AC loss, and printer parallel cable removal by the CSG-M software at
the computer.
3.
Supervision for the MKB-5/-5C and MKB-6/-6C printer is set in CSG-M. In the Network Module Map, select the
MKB and press Enter. Scroll down to Printer Option and press Enter to toggle to the correct printer. The fields
Supervised Operation and Serial Port must both be set to YES.
4.
All cables must be in rigid conduit and cannot leave the room.
5.
All circuits, except AC Input, are power limited.
or Item
button to select the next or previous setting you want to change.
and Set) again to exit default-setting mode.
PARALLEL PRINTER
(REAR VIEW)
PRINTER
CABLE SUPPLIED
WITH PAL-1
NOT SUPERVISED
Figure 4
MXL System
3
PAL-1
120 VAC
60 Hz
Advertisement
