HP 59501B Operating And Service Manual page 19

3-50 CC Programming Connections. Figures 3-14
through 3-20 illustrate the connections required to program
the CC output of the applicable power supplies. The dotted
connections represent jumpers which must be removed on
the supply's rear terminal strip. All other jumpers must be
connected as illustrated. Note that only those power supply
terminals pertinent to CC programming are shown. Complete
terminal strip details are provided in the appropriate power
supply Operating and Service manual. Most of the supplies
are programmed utilizing the connection diagram of Figure
3-14. The specific connections for each supply are tabulated
on the diagram. In all cases (Figures 3-14 through 3-20),
the 59501 B's programming output voltage is substituted for
the supply's internal reference and the 59501 B's POWER
SUPPLY FULL SCALE ADJUST potentiometers replace
HP POWER SUPPLY (SEE TABLE ! 5950® _
the supply's front panel CURRENT control.
NOTE: The dotted line connections represent jumpers
which must be removed. All other jumpers must be
installed.
MODEL NO
CUR PROG TERMINALS]
A
8 C D
6002A *
A7 A4 A5
A6
6200C, 0IB, 02B, 03B,
07B, 09B, 20B, 24B, 26B
A4 A!
A3 A5
62278,28B
A5 A6 A7
A4
6253A,55A
A4 AI
A3 A5
62568,598,60B, 618,63B
648,658,668,688,698,
716,748**-
A7 A6 A5 A4
6281A, 84A, 89A, 94A.99A
A4 AI A3 A5
6282A, 85A, 86A, 90A,91A,
96 A
A8
AI A6 A7
* IF THE 6002A IS EQUIPPED WITH OPTION OOI,
THE MODE SWITCH ON THE 6002A MUST 8E SET
TO CV OR LOCAL.
** IN THESE SUPPLIES Ai AND A3 OF THE'5950® ARE
JUMPERED TOGETHER, NOT AI AND A6.
Figure 3-14. CC Programming Connections for HP Power
3-10