Sealey VS0275.V2 Instructions

Th a n k y o u f o r p u r c h a s i n g a S e a l e y p r o d u c t . Ma n u f a c t u r e d t o a h i g h s t a n d a r d , t h i s p r o d u c t w i l l , i f u s e d a c c o r d i n g t o t h e s e
i n s t r u c t i o n s , a n d p r o p e r l y m a i n t a i n e d , g i v e y o u y e a r s o f t r o u b l e f r e e p e r f o r m a n c e .
IMPORTANT: pleAse reAd These insTrUCTions CAreFUll Y . noTe The sAFe operATionAl re Q UiremenTs, WArnings & CAUTions. Use
The prodUCT CorreCTl Y And WiTh CAre For The pUrpose For WhiCh iT is inTended. FAilUre To do so mA Y CAUse dAmAge And/or
personAl inJUr Y And Will invAlidATe The WArrAnT Y . Keep These insTrUCTions sAFe For FUTUre Use.
refer to
Wear eye
instruction protection
manual
1 . S AF E TY
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
ensure the work area has adequate lighting.
9
D O NOT touch the probe whilst switched on, it will be hot.
8
D O NOT use the tester to perform a task for which it is not designed.
8
D O NOT allow untrained persons to use the tester.
8
D O NOT use whilst under the influence of drugs, alcohol or intoxicating medication.
8
After use, clean equipment and store in a cool, dry, childproof area.
9
1.1. B RAK E F L U ID S AF E TY
Always read and comply with the warnings on the brake fluid manufacturer's container.
9
Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes rinse with plenty of water and seek medical advice.
9
if swallowed seek medical advice immediately.
Dispose of waste brake fluid in accordance with local authority regulations.
9
W ARNING ! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.
‰
W ARNING ! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
‰
1.2. PE RS ONAL PRE C AU TIONS ( W ORK ING
ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working near a
9
lead-acid battery.
have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
9
Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.
9
Wash immediately with soap and water if battery acid contacts skin or clothing. if acid enters eye, flush eye immediately with cool, clean
9
running water for at least 15 minutes and seek immediate medical attention.
remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current
9
high enough to weld a ring or the like to metal, which may cause severe burns.
2 . INTROD U C TION
The approved method of testing the water content of brake fluid. Just 3% of moisture can lower the brake fluid boiling point by over 100°C. The best
way to detect this small water content is to measure the boiling point of the fluid. The unit incorporates a heater element. lCd display and a power
lead for use on 12v DC power supplies. Works on DOT 3, 4, 5 and 5.1 specification fluids. Supplied in carry case with full operating instructions.
3 . C ONTE NTS
© Jack sealey limited
B RA K E F L U I D B OI L TE S T
V S 0 2 7 5 . V 2
model no:
Wear Warning:
protective
hot
gloves surface
W ITH B ATTE RIE S )
Original Language Version
vs0275.v2 issue:1 - 04/12/18