Table of Contents
Advertisement
This manual has important safety
information. Read through it carefully
before operating this machine to prevent
personal injury or machine damage. Learn
the operation, limitation and the specific
potential hazards peculiar to this band
saw.
Do not operate this machine unless it is
completely assembled.
Make sure the power switch is off before
plugging in power cord.
Disconnect the power cord before making
adjustment, maintenance or blade
changes.
Keep all guards and shields in place before
installing or starting up the machine.
Wear proper apparel during operation
and when servicing the machine.
Keep unauthorized personnel away.
Do not reach over or stand on any part of
the machine.
Never hold the material by hand for
cutting. Always use the vise and make
sure the material is clamped securely
before cutting.
It is dangerous to operate the machine
when the floor is slippery. Keep the floor
clean and dry. Check for ice, moisture, or
grease before entering.
Do not use the machine to cut explosive
material or high pressure vessels as it will
generate great amount of heat during the
sawing process and may ignite an
explosion.
Keep the work environment safe. Do not
use band saw in a damp or wet location.
Never operate while under the influence
of drugs, alcohol or medication.
1-2
All users must read it before performing any
activity on the machine, such as replacing
the saw band or doing regular maintenance.
Some personal protective equipment is
required for the safe use of the machine, e.g.
protection goggles.
Keep blade protection cover and wheel
covers in place and in working order.
Use recommended accessories. Improper
accessories may be hazardous.
Keep your work area well illuminated at
minimum 500 lumen.
Keep your work area clean. Cluttered and
slippery floors invite accidents.
Remove adjusting keys, wrenches
loose parts or items
from the machine
before turning on power.
Check for damaged parts. Before continuing
using the machine, the damaged part should
be checked and replaced.
Moving parts should be kept in proper
alignment and connection with the
Check for breakage, mounting and any other
conditions that may affect its operation. Any
damaged part or guard should be properly
repaired or replaced.
When a workpiece is too long or heavy,
make sure it is supported with a roller table
(recommended).
Always remember to switch off the machine
when the work is completed.
Use a sharp saw blade and keep the machine
in its best and safest performance by
following a periodical maintenance schedule.
Do not force the band saw beyond its
intended use. It is safer to operate with the
cutting rate for which it was designed.
or any
machine.
Advertisement
Table of Contents
