Control Panel (Sw-130Htsa); Control Buttons - Sharp SW-130HT Instruction Manual

and coolant will stop when the blade stops.
5. Blade descend speed control knob

Turning the knob counterclockwise increases the blade descend speed.

Blade descend speed is a determining factor to a good cutting time and quality cutoff surface.

Also commonly known as the flow control valve

CONTROL PANEL (SW-130HTSA)

No.
1 Vise clamp/open switch
2 Coolant pump ON/OFF switch
3 Saw blade start button
4 Saw blade stop button
5 Saw bow up button

Control Buttons

1. Vise open/clamp switch
When the switch is turned to the left, the vises open. When the switch is turned to the right, the vises
close until the operator lets go of the switch or until the full stroke vises are clamped together.
Make sure the material is securely clamped by the vise before cutting.
After the blade motor is running, the function of this switch is disabled for the safety concern.
2. Coolant pump on/off switch
Name No.
6 Saw bow down button
7 Saw bow quick approach button
8 Emergency stop button
9 Power indicator lamp
10 Blade descend speed control knob
Name
4-5