HP 61010A Owner's Manual page 13

Trying Out Your Instrument
2
Introduction The following step-by-step procedure allows you to
perform some simple instrument operations. This
procedure is especially suitable for first time users who
want to quickly become familiar with the basic operation
of the Digital
I/O.
Chapter 3 contains additional operating
information that you can use once you have learned the
basics in this chapter.
The Procedure
Trying out your instrument consists of pointing to and
selecting various interactive fields on the Soft Front Panel.
Before you try out your Digital I/O, you should have:
connected it to the interface, applied power, loaded the
operating system, renamed (or erased) HPSTATE.HPC to
return the instrument to its factory default settings, and
run PANELS as explained in Chapters 2 and 3 of your
System Owner's Manual.
NOTE
If the output of your instrument is connected to an application
,
he aware that following these instructions will set output bits 2,
5, and 6 high, You may want to disconnect your output
connector.
Trying Out Your instrument 2-1