HP 61010A Owner's Manual page 9

terns Supplied
In asynchronous mode, the computer alone controls the
transmission of data on the Digital I/O's input and output
bits. Any data that is sent by the computer immediately
appears on the output bits. Data that appears on the input
bits is immediately read into the computer. Data
transmission is not dependent on any control signals.
In addition to this manual, check that you have received
the following items with your Digital I/O:
Power Pack
• an ac power transformer with an attached
one metre cable. The transformer type was determined by
country of destination. Chapter 2 of the System Owner's
Manual lists the different types and their part numbers.
Power Cord
- connects the Power Pack to an ac source.
Plug type was determined by the country of destination.
Chapter 2 of the System Owner's Manual lists types and
part numbers.
Instrument Interconnect Cable (8120-4631)
■ connects
your instruments to the system interface. Refer to Chapter
2 of the System Owner's Manual.
I/O Terminal Connectors (1252-0928)
- two connectors
(one male, one female) with covers are for application
connections to the Digital I/O. The third male connector is
used for verification.
Update Pages
• if applicable, update pages are included.
Replace the obsolete pages with the new ones before you
use this manual.
Product Description 1*3