HP 61010A Owner's Manual page 43

1. Solder the wires or cable (1) from your application to
the solder pins on the connector (2). Figure 4-3 shows
the location of the data bits and control signals on
each connector.
2.
Place the connector inside the cable damp (3) and
route the wires out of the opening at the back of the
cable damp.
3.
Insert the proper strain relief (4) over the wires, and
insert the solid plug (5) in the opening on the side of
the cable clamp.
4.
Close the cable clamp and tighten the three cover
screws (6).
5.
Attach the slide latches (7) to the connector using the
hardware (8) that is supplied. The lip on the side of
the slide latch must overlap the edge of the
connector. Do not overtighten the screws.
Front Panel Connections 4-3