Ceccscesesseessssees - Bosch Blaupunkt LEXINGTON CM84 Manual

High-power fm/am/cassette receiver with cdg changer control and fully-detachable face
Table of Contents

Advertisement

Troubleshooting Guide
The following check will assist in the correction of most problems which you may yencounter with your unit
Before going through the check list below, refer back to the connection and operating procedures.
General
* Adjust the volume with the + button.
* Set the fader control to the center position on the 2-speaker
system.
« Remove the front panel and clean the connectors. See
"Cleaning the Connectors" of "Maintenance" for details.
* Yellow lead is not connected —> Connect yellow lead.
« Demonstration mode is active —> To stop, press DSC
button for 4 seconds.
No sound.
indications do not appear on the
|
display window.
-
|
Demonstration message appears when
| unwanted.
Radio reception
Cause/Solution
Preset stations are not receivable.
* The broadcast is too weak.
Automatic tuning is not possible.
+ The broadcast is too weak. —> Use manual tuning.
Travel Store feature does not complete
,
«+ Not enough broadcast frequencies are receivable.
storing of six stations.
|
CD operation*
| CD play does not start.
« Dusty or defective disc. —
|
* The ambient temperature is more than 50°C (120°F).
The disc cannot be loaded or is
* The disc is inserted with the labeled side downwards.
automatically ejected.
|
|
2
| The operation buttons do not work.
|
The built-in microprocessor has malfunctioned.
|
|
——> Press the reset button.
The sound skips due to vibration.
« The unit is installed at an angle of more than 20°.
* The unit is not installed on the sturdy part of a car.
« Dusty or defective disc.
Error displays
Dipl
Insert the disc magazine with discs into
NO
MAG*
The disc magazine is not inserted in the
CD changer
the CD changer.
% | No disc is inserted in the disc
Take out the magazine and insert the
NO DISC
sas
The disc is any.
Clean the disc.
Solution
The disc is inserted upside down.
Insert the disc correctly.
The CD changer cannot be operated
Check the changer ciasormrag
because of some problem.
Press the reset button of the main unit.
Attempt to program TPM on disc with
| Name the disc first.
no name.
|
,
Attempt to name more stations or discs
| than is possible.
Erase other names first.
"When the optional CD changer(s) is (are) connected.
if the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer.
22

Advertisement

Table of Contents
loading

Table of Contents