Table of Contents
Advertisement
Detachable Face
Detaching & Attaching the Face:
The face of this unit can be detached and taken with you to prevent it from being stolen.
Detaching the Face:
Before detaching the face, be sure to press the PWR Button first. Then press the REL (Release)
Button and detach the face by gently pulling it towards you as illustrated.
Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it from
the chassis.
Attaching the Face:
Apply the right hand side of the face to the chassis by sliding (part 8) of the face to (part A) at the front
of the chassis. Gently push the left side of the face against the front of the chassis until if snaps into
place.
Note: Make sure that the face is inserted right side up. Do not press against the display window. Do
not press hard against the face when attaching it to the chassis, it may be easily attached with gentle
pressure. When carrying the face with you, put it in the carrying case. Do not expose the face to direct
sunlight, heat sources such as hot air ducts or leave it in a humid place. Never leave it on the dash
poard of a vehicie parked in direct sunlight, where there may be a considerabie rise in temperature
inside the vehicle.
Advertisement
Table of Contents
