Run A Method - GE AKTA ready XL Operating Instructions Manual

6 Operation

6.2 Run a method

6.2

Run a method

Introduction
Precautions
Start a run
134
TeDIS Valid on Date Printed
Running a method or phase on ÄKTA ready XL can be a largely automatic procedure.
User interaction can be mainly required in the preparation phase, which includes
connecting the column and the required containers, checking that all connections
are correctly assigned, and that flow kit type and volumes are correct. For further in-
formation on method creation, refer to the relevant control software documenta-
tion.
This section describes an example on how to start, monitor, end and evaluate a run
using UNICORN control software.
For other control softwares, refer to the software documentation to create similar
methods.
WARNING
Before attempting to perform any of the procedures described in
this chapter, you must read and understand all contents of the
corresponding section(s) in the links as listed below:
•
General precautions, on page 13
•
Personal protection, on page 15
•
Operation, on page 18
Starting a run is done from UNICORN after first having checked that all inlets and
outlets are correctly assigned and that the volumes of inlet and outlet containers are
correct.
Make sure the installation switch is set to Run.
Step Action
1 In the System Control module, click Run on the File menu.
ÄKTA ready XL Operating Instructions 29281616 AE
Printed on: 15-09-2023 11:27:35 ***