Hp 30311A Power Supply With Existing Cables - HP 3000 Series Installation And Service Manual
Intelligent network processor (rnp)
Hide thumbs
Also See for 3000 Series:
- Handbook (280 pages) ,
- Installation and service manual (74 pages) ,
- Installation manual (42 pages)
Table of Contents
Advertisement
Installation
c.
Remove the two screws on the left upper and lower corners
of
the
power
supply.
Mount the Memory Power Jumper PCA board
(part no. 30380-60033) on the left edge of the power
supply,
using
the two longer screws, two flat washers, and two lock-
washers supplied with the
jumper
board.
(Refer
to
figure
2-5.)
NOTE
If the location of the cable
clamp
brace
interferes
with mounting the jumper board
on the power
supply
,
the
cable
clamp
brace
can
be loosened and slid either up
or down on its mounting rails.
d.
Unplug the existing cable connector from receptacle J2 on the
power supply, and plug it into receptacle
J7
on
the
newly
attached jumper board.
(Do not remove the other plugs in J3,
J4, and JS.)
J3
J4
Figure 2-4.
HP 30311A Power Supply with Existing Cables
2-11
Advertisement
Table of Contents
