PDU8000 DC Combiner Cabinet
User Manual
Name
Output power
cable terminal
Signal cable
terminal
4.3 Unpacking and Checking
Step 1 Verify that the cabinet package is intact. If any damage is found, notify the carrier
immediately.
Step 2 Remove the unloading ramp and unpack the cabinet. Ensure that the cabinet
exterior is in good condition and free of collision and scratches. If any damage is
found, notify the carrier immediately.
Step 3 Check the type and quantity of fittings against the packing list. If some fittings are
missing or do not match the models in the packing list, record the information
and contact the supplier immediately.
----End
4.4 Moving the Combiner Cabinet
Context
Take protective measures during movement to prevent toppling and bumping.
Procedure
Step 1 Open the front and rear doors of the combiner cabinet.
Step 2 Remove the four bolts securing the combiner cabinet and the pallet at the bottom.
Issue 02 (2022-08-10)
Terminal Specifications
Bare crimping terminal, DT, 70 mm
Single-cord end terminal, 0.5 mm
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installation
2
, M12, tin plating
2
24