PDU8000 DC Combiner Cabinet
User Manual
3.
----End
4.5.2 Installing the Combiner Cabinet (ESD Floor)
Context
A support is required when the combiner cabinet is installed on an ESD floor. The
support height depends on the height between the ground and the ESD floor.
Procedure
Step 1 Adjust the anchor bolts of the combiner cabinet using an adjustable wrench until
the castors hang in the air.
Step 2 Lift the combiner cabinet onto the support and align the cabinet mounting holes
with the support mounting holes.
Step 3 Adjust the anchor bolts of the combiner cabinet using an adjustable wrench, and
level the cabinet with a level.
Issue 02 (2022-08-10)
Figure 4-9 Installing front and rear anchor baffle plates
Clamp the anchor baffle plates on the sides into those on the front and rear.
Figure 4-10 Installing side anchor baffle plates
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installation
30