Information About The Batteries; Installation Of The Wall Bracket - Silvercrest SAS 7.4 LI C2 Operating Instructions Manual

Information about the batteries

■ This handheld vacuum cleaner is powered by rechargeable lithium-ion batteries .
Before using the handheld vacuum cleaner for the first time, the batteries must
be charged . The charge indicator lamp 7 lights up red during charging . As
soon as the batteries are fully charged, the charge indicator lamp 7 lights
up green .
■ For care of the batteries, we recommend the following: once the batteries
have been charged, disconnect the mains adapter 4 from the mains socket .
Do not plug the mains adapter 4 back into the mains socket until the charge
indicator lamp 7 flashes green .
■ If the handheld vacuum cleaner is deep-discharged, the charge indicator
lamp 7 flashes alternately red and green (approx . 1 minute) . In this case,
switch off the appliance and start charging .

Installation of the wall bracket

DANGER! ELECTRIC SHOCK!
► Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket 3 .
Drilling into a current-carrying electric cable can be potentially fatal!
1) Place the barrel plug 5 of the mains adapter 4 into the wall bracket 3 as
shown in the following diagram:
–
Open up the small cover .
–
First, feed the cable through the cable routing and then push the barrel
plug 5 into the opening in the wall bracket 3 so that it is firmly in place .
–
Then close the small cover again .
SAS 7.4 LI C2 GB │ IE │ 21 ■