Hitachi airCore 700 Installation & Maintenance Manual page 16

INSTALLATION & MAINTENANCE MANUAL
(2) According to different controller installation methods, choose one of the following two ways to install the
mounting plate and connect the cable .
Method 1 : To mount the controller directly on the surface of a wall:
A. Secure the mounting
plate onto the wall with
M4×16mm screws (supplied)
Method 2 : to install the controller on a surface mounting box:
a. Prepare the optional field-supplied surface mounting box which can fit the mounting plate.
b. Feed the cable through the conduit in the wall.
Mounting Plate
c. Cut away the insulation at the end of the cable and clamp the M3 solderless terminals (field-supplied).
(3) Re-attach the controller body to the controller mounting plate. Be careful not to pinch the cable when
attaching it.
(4) After installation, remove the protective film from the LCD screen.
Cable
Cable Tie
(Field-Supplied)
Surface Mounting Box
M4 Screws
(Field-Supplied)
Draw-out Hole
D. Attach the cable-tie to the cable
on the inside of the draw-out hole.
B. Peel away the insulation
B
A
at the end of the cable
and clamp the M3 (field-
supplied) solderless
terminals .
C. Feed the cable with its
sheath peeled through
the groove.
B A
Connect the terminals.
12
Unit: mm
111
30 30
7 23 23
3-7
2-4.3
23
Remove the
protective film.