Hitachi airCore 700 Installation & Maintenance Manual page 29

7.1.2 Zone Configuration Setting from Wired Remote Controller
The Wired Remote Controller model compatible with the Zone Interface Box is PC-ARFG2-Z.
The Wired Remote Controller installation setting steps are as follows.
Zone Installation Menu
If the wired controller is connected to the zone interface box, "Zone Installation Menu" is displayed in "Service
& Installation Menu".
Step1. Select "Zone Installation Menu" and press "OK".
NOTES:
•
When "common zone setup" is not set, "
setting items and they cannot be set.
•
When "common zone setup" has been set, but "zone activation"
has not been set, "
"Zone Labeling".
7.1.2.1 Common Zone Setup
A common zone is one that does not have a damper and damper motor installed. Whenever the air
conditioning system is operated, this zone is always ON. Refer to Installation and Maintenance Manual of Zone
Interface Box for detailed information.
Step1. Select "Common Zone Setup" and press "OK".
Step2. Press "OK".
Step3. Press " " or " " to select the setting and press "OK".
Step4. Press " " to return to Zone Installation Menu.
" are displayed for other
" are displayed for other setting items after
INSTALLATION & MAINTENANCE MANUAL
25
Service & Installation
Service Menu
Installation Menu
Check Menu
Zone Installation Menu
Select
OK
Zone Installation Menu
Common Zone Setup
Zone ActiVation
Zone Labeling
Nominate Spill Zone(s)
Sensor Assignment
OK Select
Zone Installation Menu
Common Zone Setup
Zone ActiVation
Zone Labeling
Nominate Spill Zone(s)
Sensor Assignment
OK Select
Common Zone Setup
Common Zone : Available
OK Select
Common Zone Setup
Available
Not Available
Select
OK
(Mon) 16:30
Back
(Mon) 16:30
Back
(Mon) 16:30
Back
Back
Back