Sanyo R227 Instruction Manual page 3

| SAFETY PRECAUTIONS
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER(OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.(The
Caution Marking and Rating Plate is located at the bottom
enclosure of the unit.)
INFORMATION:
This equipment has been tested and found to comply with
the limits for a Class B digita device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This
and can radiate radio freq
equipment generates, uses
uency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interferen
However, there is no guaran
occur in a particular installa
ce to radio communications.
ee that interference will not
ion. If this equipment does
А DANGEROUS VOLTAGE cause harmful interference to radio or television reception,
The lightning fash with arrowhead symbol i А А
within an equilateral triangle is intended to alert which can be determined by turning the equipment off
the user to the presence of uninsulated and on, the user is encouraged to try to correct the
dangerous voltage within the product's interference by one or more of the following measures:
enclosure that may be of sufficient magnilude
to constitute a risk of electric shock fo persons.
ATTENTION
The exclamation point within an equilateral
triangle is intended to alert the user lo the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
e Reorient or relocate the receiving antenna.
e Increase the separation between the equipment and
receiver.
e Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
e Consult the dealer or an experienced radio / TV
technician for help.
FCC WARNING:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment
may cause harmful interference unless the
modifications are expressly approved in the instruction
manual. The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
Changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
Shielded cables must be used this unit to ensure
compliance with Class B FCC limits.
Caution: To maintain compliance with the FCC's RF
exposure guidelines place the base unit at least 20 cm
from the nearby persons.
Use only the supplied antenna. Unauthorized
antennas, modifications, or attachments could damage
the transmitter and may violate FCC regulations.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC
connection. Lightning and power surges ARE NOT
covered under warranty for this product.
US-1