Setting Beeper Volume - Brother FAX-775 Owner's Manual

Setting Beeper Volume
You can set the heeper to 1,0%V, or {)_l _, The default setting is 1,04_', When
the beeper is set to I O.W or/IHH, the fax machine beeps every time you press a key
or make an error, and at the end of fax sending or receiving.
Press Menu/Set 1,3,
[ 3,, BEEPER ]
C'-O
Press or to select your setting,
and then press Menu/Set.
<<5
Press Stop/Exit.
Choosing the Handset Volume (For Volume Amplify)
Before you hegin to use the nmchine, you must decide if you need to set the handset
volume m A_/P_ H _ :ON Ii_r a user who is hearing-impaired. The AMPLIFY
volume level complies with FCC standards.
VOLUME AMPLH;'Y: OFF
This default setting is appropriate if none of the users are hearing-impaired. During a
Cb
conversation, users can press Volmne or on the control panel to adjust the volmne
to lOW or H_(}£ When the handset is replaced, the handset volume will remain
until you change it again.
This setting is appropriate if some of the users are hearing-impaired. During a
C_
conversation, users can press Volmne or on the control panel to adjust the volmne
<'O
to lOW, HIGH or AMPI H'Y. When the handset is replaced, the handset volume
returns to the default setting of I OW.
VOLUME AMP[ H;'Y:ON.PE_MANEN_
Choose VOL AMPI J FY:ON-PE/_MANENT if all of the users are hearing-
db
impaired. During a conversation, users can press Volume or on the control panel to
adjust the volmne m It)W, }{_G }{ or A'_/PI 1_"5. When the handset is replaced, the
handset volume returns to the default setting of AMPI _1'5".
When you press Volume or on the control panel to adjust the volume, the LCD shows
<£)
the setting you are choosing. Each key press changes the volume to the next setting.
_1= WARNING
It is important that you do not choose PERMANENT unless all users are
hearing-impaired. Otherwise, the default setting of AMPLIFY may damage the
hearing of some users.
INITIAL SETUP 4-4