Table of Contents
Advertisement
OPERATION
5
•
Ambient temperature 0-9SoF
•
Atmosphere 86-106 kpa
•
VOLTAGE: l1SV 160HZ
•
Position the water cooler on the horizontal, structurally sound ground. Leave
an adequate open space (10-20 cm) behind the water cooler for good
ventilation.
•
When using the bottles holding ultra-pure water, distilled water or space
water with the so-called clever
lid,
tear off the hygienic labels on the lid. Place
the bottles at the intake, then the core of water guard will automatically
open the valve and seal it in the meantime, when moving the bottles, the
valve will also seal automatically to avoid any possible oozing.
•
Push the hot water valves, bubbles are generated inside the bottle,
indicating that water is flowing into hot water and cold water tanks, keep
pressing the hot water valve until water flows out, dispensing cold water
required need no particular adjustment.
•
Caution: Do not connect the electrical power plug until water comes out of
the hot water tap.
•
After water is flowing out from the hot tap, then we can open the switch at the
back side.
•
Turn the heating switch on, the red indicator is on and the heating system
starts working. When the hot water comes up (186-203 0 F) or so, the red light
goes off, the heating system stops working, and it is on a warm keeping
status.
When the hot water temperature is lower than 18SoF, the heating system
will
resume working again automatically.
•
Turn on the cooling switch, the green indicator is on and the cooling system
starts working. When the cold water falls down to 41-S00F(for compressor-
cooling), the green light goes
off,
the cooling system stops working, and it
is on a cold keeping status.
When the cold water temperature goes up to a set degree, the cooling
system will resume working again
atomically.
•
Since the temperature has already been adjusted before leaving the factory, it
is unnecessary for customers to set the temperature.
•
If device is not applied for a long time, after the hot water cools down,
please remove the power plug and revolve the drain the rest water in
the hot tank then tighten the cap open the cold water tap to drain the rest
water in the cold tank.
Advertisement
Table of Contents
