Table of Contents
Advertisement
6
OPERATION
•
If there is no water flowing from cooling tap, please shut down the cooling
switch until there is water flowing out.
Steps of changing water:
1.
Open the door gently to keep it at suitable angle, then pullout the water tube.
2. After pulling out the water tube, you can hang it on the hook of the door.
3.
Remove the cap of the bottle, put the water tube into the new bottle and press
it tightly or the pump may not pump the water into the water tank.
4. Put the bottle into the cabinet of the water dispenser.
5. The diameter of water bottle should be less than 270mm .
•
Instructions of water shortage indicator light:
1.When there is water in water shortage tank, the water shortage indicator light is
off.
2. When the water tank is over flowing, the water shortage indicator light is off
and alarms for one minute.
3. When there is no water in the water shortage tank, water shortage indicator
light flickers.
4. When there is water in storage tank but no water in bottle, the water shortage
Indicator light in on
&
alarm for 30 seconds.
5. When the shortage water tank and bottle are both lack of water, the whole
machine is locked, the water shortage indicator light flickers and alarms for 30
seconds.
6. When opening the
door,
the pump stops working, if the water level in the cold
tank is higher than the water control level, the machine will still work normally.
7. When using a 5 gallon rectangular bottle, slide into place as shown below.
8. After changing water and closing the door, hot and cold tank have been full of
water, then water leakage lamp will be off itself.
.\
Advertisement
Table of Contents
