Table of Contents
Advertisement
Adjusting the color convergence
This projection TV uses three separate TV tubes: red, green, and blue.
The red, green, and blue images are projected onto the screen where
they converge to form a full-color picture. You can see a dear picture
only when the three images converge correctly. Convergence can drift
over time or if you move the TV. If you can see clear images on your
TV screen, skip this procedure.
Make this adjustment only after the TV has been on for at least 30
minutes.
To check and adjust the color convergence:
1. Press MENU, and then press • or • until the PICTURE menu
appears.
2. Press • or • to highlight CONVERGENCE.
@@®@@@
PICTURE
ANTENNA
MODE
SPORTS
FLESH
TONE
ON
NOI
SE
REDUCTION
OFF
COLOR
LIGHT
RECALL
POWER
C_LE MUTE T_,oEo _,ME_
NO ©
--
Number
MENU
ENTER
EXIT
3. Press • or • to display the center convergence menu.
t
m
BLUE
ENTER:TO
SELECT
COLOR
EXiT
:TO
SELECT
POSITION
If you see separate color lines (red, blue, and green or white), you
need to adjust the convergence.
4. Press ENTER to highlight RED or BLUE.
5. Press • (up), • (down), • (left), or • (right) to converge the red
or blue line into the green (or white) line. When the convergence
is adjusted correctly, you will see two single, crossed white lines.
6. Press EXIT to display the circumference convergence menu.
7. Press the corresponding
Number button (1-4 and 6-9) to select
the area of the screen you want to adjust.
8. Press ENTER to highlight RED or BLUE.
4-
+
RED
r_
ENTER:TO
SELECT
COLOR
EXiT
:TO
SELECT
POSITION
9. Press •••
• to converge the red or blue line into the green (or
white) line.
Repeat steps 8 and 9 until you see two single, crossed white lines.
10. Press EXIT once to select another area to adjust in the
circumference convergence menu, and then repeat steps 7-9.
11. Press EXIT twice to close the convergence menus.
Advertisement
Table of Contents
