Adding And Erasing Channds Manually; Changing Channds; Adjusting The Color Convergence - Toshiba COLORSTREAM 43A10 Owner's Manual

Adding and erasing channels manuaRy
After you've programmed the channels, you can add or erase specific
channels.
To add or erase channels:
1. Select the channel you want to add or erase using Channel A or
Y. If adding channels, you must select the channel to add by
using the Channel Number buttons.
2. Press MEN U, then press 4 or _ until the SET UP menu
appears.
3. Press A or V to highlight ADD/ERASE.
O SET UP
LANGUAGE ENGLISH
CLOCK SET
ANT1/2 ANT1
TV/CABLE CABLE
4. Press @ or _ to select ADD or ERASE, whichever function you
want to perform.
5. Repeat steps 1-4 for other channels you want to add or erase.
Changing channels
To change the channel, you can:
• change the programmed channels using the remote control
• select a channel directly using the remote control
• scan the channels using the TV buttons
To change to the next programmed channel:
Press Channel A or Y on the TV or remote control.
To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0-9 and 100).
For channels 100 and higher, press the 100 button, then the next
two numbers. For example, to select channel 125, press 100-2-5.
Adjusting the color convergence
This projection TV uses three separate TV tubes: red, green, and blue.
The red, green, and blue images are projected onto the screen where
they converge to form a full-color picture. The picture will be clear
only when the three colors converge correctly. Convergence may drift
over time or if you move the TV. If the images on your screen are
clear, skip this procedure.
Note: The TV should be on for at least 30 minutes before you make
this adjustment.
MENU
CHANNELTA
Channel
Number
MENU
Channel AT
19