Toshiba COLORSTREAM 43A10 Owner's Manual page 12

Hide thumbs Also See for COLORSTREAM 43A10:
Table of Contents

Advertisement

To control a cable TV converter:
Program the remote control to recognize the brand of yonr
converter. The shaded buttons shown at right will control the
cable TV converter.
Set the TV/CABLE/VCR
switch to the CABLE position.
Programming
the remote control for use with a
VCR or a cable TV converter
This remote control is pre-programmed
to operate Toshiba VCRs. To
use VCRs or cable converters other than Toshiba models, you must
follow the steps below before yon operate yonr remote control.
1. Refer to the "V(;R code table" or "Cable TV converter code
table" on pages 13-14 to find the number that corresponds to the
brand name of your VCR or converter.
If more than one number is listed, try each one separately until
yon find the one that works.
2. If yon are reprogramming
the remote control to operate yonr:
* VCR, set the TV/CABLE/VCR
switch on the remote control
to VCR.
.
.
* Cable converter, set the TV/CABLE/VCR
switch on the
remote control to CABLE.
Hold down the RECALL button while using the Number
buttons (0-9) to enter the three-digit code number of your brand
of VCR or converter.
Point the remote control at the VCR or converter and press
POWER to test the code number.
If the VCR or converter turns on, you have entered the right
number.
If the VCR or converter does not respond to the remote control,
yon may have entered the wrong number. Repeat steps 1-4 with
another code number.
5. Reset the TV/CABLE/VCR
switch to TV to control the TV.
I
RECALL
R_M(_
P°w-_ER
- POWER
-- Channel
Number
Enter
Channel AT
Note:
" Each time you replace the batteries, you
must ref)rogmm the remote control
, Some newer VCRs are capab/e of working
on either of two remote codes. These VCRs
havea switch labeled"VCR I/VCR2."
ffyour VCRhasthiskindof switch, i t may
not
respondtoanyof thecodenumbers for
your VCR brandname.In thiscase, s et the
switchto the
other position
(VCR7or
VCR23
andrepmgram theremotecontrol
For future reference,
write down the code numbers
you used:
VCR code
Cable code
12

Advertisement

Table of Contents
loading

Table of Contents