Adding Channds To The Tv's Memory; Programming D_Anncls Automatically - Toshiba COLORSTREAM 43A10 Owner's Manual

Adding channels to the TV's memory
Your TV will stop on specific channels that are stored in the TV's
channel memory when you press Channel A or V. Use the steps
below to set all active channels in your area automatically.
Programming channels automaticaRy
Your TV can automatically detect all active channels and store them
in its memory. After the TV has stored the channels in its memory,
you can erase channels or add your favorite channels. If you use both
ANT-1 and ANT-2 terminals, you must program channels for each
input source.
To add channels:
1. Press MENU, then press 4 or _" until the SET UP menu
appears.
2. Press A or Y until the TV/CABLE is highlighted.
3. Press @ or _" to highlight either TV or CABLE, depending on
which you use.
O SET UP
LANGUAGE ENGLISH
CLOCK SET
ADD/ERASE ADD
If'you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press V to select CH PROGRAM.
MENU
AT_ i_
Channel AT
O SET UP
LANGUAGE ENGLISH
CLOCK SET
ANT1/2 ANT1
5. Press "9 or _ to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel A or Y to view the programmed channels.
18