Toshiba COLORSTREAM 43A10 Owner's Manual page 20

To check and adjust the color convergence:
1. Press MENU, then press 4 or _ until the PICTURE menu
appears.
2. Press A or V to highlight CONVERGENCE.
O PICTURE ANTENNA
MODE SPORTS
FLESH TONE ON
NOISE REDUCTION OFF
COLOR
3. Press 4 or _" to display the center CONVERGENCE menu.
.
.
.
7.
+
I'_BLUE
ENTER:TO SELECT COLOR
EXIT :TO SELECT POSITION
If you see separate red, blue, and green crossed lines (or red and
blue shadows next to white lines), you need to adjust the
convergence.
Press ENTER to highlight RED or BLUE, depending on which
color needs adjusting. If both red and blue need adjusting, you
will need to perform steps 4 and 5 twice.
Press at (up), V (down), @ (left), or _" (right) on the remote
control to converge the red or blue lines into the green lines,
which will turn completely white when correctly adjusted.
Press EXIT to display the circumference CONVERGENCE
menu.
Press the corresponding Number button (1-9) to select the area
of the screen you want to adjust.
-- Number
MENU/ENTER
I
EXIT
+
8. Press ENTER to highlight RED or BLUE, depending on which
color needs adjusting. If both red and blue need adjusting, you
will need to perform steps 8 and 9 twice for the selected area.
-t-
REDmlnlt
ENTER:TO SELECT COLOR
EXIT :TO SELECT POSITION
9. Press atV4 _" to converge the red or blue line into the green line,
which will turn completely white when correctly adjusted.
10. Press EXIT once to select another area to adjust, then repeat steps
7-9.
11. Press EXIT twice to close the CONVERGENCE menu.
20