Siemens SICHARGE D Product Information page 82

Installing the cable management
3. Place the bezel bracket on the left and bezel bracket on the right parallel to the cutout. Screw the mounting plates down with
the 4 M12x30 hexagon screws. Make sure that the bezel brackets do not twist when screwing in. Do not tighten the screws yet.
Figure 4 Screwing the mounting plates
4. Place the bridge between the left and right mounting plates. The four threaded bolts must pass completely through the holes of
the bridge. Screw in the bridge with four M6 hex nuts. Do not tighten the nuts yet.
Figure 5 Screwing in the bridge
82
Installation of the cable management system
A5E53160522-AA, 11/2023